4.4.1 Changing and Saving Values Example Procedure
This section contains an example of how to change and save values in Menu
Mode. Use the steps in Table 4–6 to perform the following tasks:
•
Enter Menu Mode
•
Change the baud rate from 4800 bits/second to 9600 bits/second
•
Save the new value in NVRAM
•
Exit Menu Mode
Before You Begin
This example assumes that the printer is using the factory default values
in ROM. You will use Test Print A to verify the changes you make. Print
a copy of Test Print A before beginning this example (Section 2.9). Be sure
that all printing has stopped and the display reads 00 READY before you
make any changes.
Table 4–6: Changing and Saving Values
Operation
Display Reads
1. Press
On Line
to place the
printer off line.
— The On Line indicator
goes off.
00 READY
2. Press
Menu
to place the
printer in Menu Mode.
FONT/FEED LAYOUT
3. Press
.
five times to
scroll the display to
the INTERFACE menu.
INTERFACE SAVE->
4. Press
r
Enter
to enter
the INTERFACE menu.
i/f baud rsmode
5. Press
.
once to
display the
baud feature.
baud rsmode dtr
4–12
Operator’s Guide
Summary of Contents for DEClaser 1100 Series
