Hardware Installation and Configuration
2–7
Select the Manual Setup option to configure the adapter with your own settings.
Operating Mode:
Medium Type:
Full-duplex:
Boot ROM:
LJ-5246.AI4
Manual Setup Menu
Plug & Play
Auto Detect
Disabled
Disabled
Power-up I/O :
Power-up IRQ :
Power-up Status :
To select a suitable configuration, specify the following:
•
Medium Type (auto-detect 10BaseT, 10Base5, or 10Base2).
•
Full-duplex (enabled or disabled). The default is disabled.
•
I/O Base (200H to 3E0H). The default is 300H.
•
Interrupt (2 to 15). The default is 3.
•
Boot ROM (disabled or set at a 16 KB address). The default is disabled.
7. Save the selected configuration (by pressing the space bar).
The 1Step utility will reboot your system if you have selected the Default
Setup option or enabled the boot ROM.
8. Select the Diagnose the Adapter or Diagnose EEPROM option from the
Main Menu to test the adapter components and installation, if necessary.
9. Select the Run Diagnostics on Network option to verify the adapter’s ability
to communicate with another device on the network. (See the Network
Diagnostics section in Chapter 3 for more information.)
10. Select the Exit Setup option to return to the 1Step main screen.
11. Click on Exit to return to the DOS prompt.
