Before You Start
xi
Quick Installation
The DE305 distribution diskette contains the menu-driven 1Step Installation
utility that provides quick adapter hardware configuration, software installation,
and diagnostics for NetWare and non-NetWare operating systems. (See the
Hardware Configuration section in Chapter 2 for more information.)
To install the DE305 adapter and the 1Step utility, use the following procedure:
1. Power down your PC, then install the DE305 into an empty 16-bit ISA slot.
2. Power up your system.
3. When the DOS prompt appears, insert the DE305 distribution diskette into
drive A, then enter the following command:
C:> A:\1STEP
4. Press Enter to display the 1Step main screen:
5. Select the Hardware Configuration option from the main screen. If you have
multiple adapters installed, identify the one you wish to configure by
selecting the corresponding MAC address from the LAN Adapter list.
6. Select the View Current Configuration option from the 1Step Main Menu to
verify the hardware settings.
7. Select the Default Setup option if your computer supports Plug and Play.
Select the Manual Setup option if your computer does not support Plug and Play
or if you need to change the default settings.
8. Save the configuration selected in step 7.
The 1Step utility will reboot your system if you select the Default Setup option
or enable the boot ROM.
9. Run diagnostics on the adapter and EEPROM.
10. Run diagnostics on the network.
11. Select the Exit option to return to the 1Step main screen.
12. Select Exit to return to the DOS prompt.
