1–2
Introduction to the CLI
CLI Reference Manual
HSZ40 Array Controller
CLI Overview
The command line interpreter (CLI) is one of the user interfaces to the StorageWorks™
array controllers in your subsystem. The CLI commands allow you to manage the
subsystem by viewing and modifying the configuration of the controllers and the devices
attached to them. You also use the CLI to start controller diagnostic and utility programs.
CLI commands for configuring and viewing the controllers use the relative terms
THIS_CONTROLLER and OTHER_CONTROLLER. T
HIS
_
CONTROLLER
always refers to
the controller that is running the current CLI session. You may have a maintenance
terminal or PC directly connected to the terminal port on the front of the controller, or you
may be using a virtual terminal connection through the host bus. In either case,
T
HIS
_
CONTROLLER
is the one that you are interacting with directly. This is shown in Figure
1–1.
Figure 1–1 Identifying T
HIS
_
CONTROLLER
, O
THER
_
CONTROLLER
THIS_CONTROLLER
OTHER_CONTROLLER
CXO-5193A-MC
O
THER
_
CONTROLLER
always refers to the controller that is not running the current CLI
session
the one that is not connected to a terminal or terminal session.
Summary of Contents for HSZ40
Page 6: ......
Page 24: ...2 12 ADD RAIDSET See also ADD UNIT DELETE SET RAIDSET SHOW RAIDSET INITIALIZE ...
Page 101: ...HSZ40 Array Controller CLI Reference Manual Glossary ...
Page 112: ......