Installing the Printer
1.4 Testing the Printer
2.
Make sure the rollers on the bail bar are fixed in their correct grooves (see
Figure 1–8), and close the front cover.
The bail rollers should be fixed as follows:
•
In most circumstances, the left bail roller must be fixed at the groove in
front of ruler position 40, and the right bail roller at the groove in front
of ruler position 90. See Figure 1–8, part B.
•
When the paper width is set to 1"–8" in Set-up, use the other two
grooves marked on the platen, located in front of ruler positions 20 and
60. See Figure 1–8, part A.
NOTE: If you set the rollers in the incorrect grooves, there is high risk
of a paper jam. For more information on paper width configuration,
refer to Section 3.4.
1–12 Installing the Printer