Loading the Paper
3.3 Adjusting the Printhead for Paper Thickness
3.3 Adjusting the Printhead for Paper Thickness
You must adjust the printhead to the setting appropriate for the stationery you
are using. You adjust the printhead by using the printhead adjustment lever
(see Figure 3–14). The following table shows the settings:
Table 3–3 Adjusting the Printhead for Paper Thickness
Lever
Position
Housing
Marking
Number of Copies
Maximum Thickness
0
0
Needle wear recovery only
0.125mm
1
-
Original only
0.125mm
2
-
Or 1 copy
0.200mm
3
3
Or 2 copies
0.280mm
4
-
Or 3 copies
0.360mm
5
-
Or 4 copies
1
0.360mm
6
6
Non-printing position
7
Cartridge
symbol
Changing the ribbon cartridge
position
1
You must use the Pull Tractor when the lever is in this position.
3–20 Loading the Paper