replacing the ribbon
33
Operator’s Guide
Press ON LINE to place the
printer in offline mode, and open
the printer cover.
Remove the old ribbon:
Raise the forms thickness
lever as far as it will go.
Press in on the hub latches
and lift the ribbon spools off
the hubs. Lift the ribbon out
of the ribbon path. (Refer to
the ribbon path diagram on
the shuttle cover.)
Discard the old ribbon.
If necessary, clean the interior
of the printer. (See page 59.)
Forms
Thickness
Lever
Hub Latch
Summary of Contents for LG plus Series
Page 8: ...ii Table of Contents...
Page 26: ...18 Operator s Guide...
Page 62: ...54 Operator s Guide...
