replacing the ribbon
34
Operator’s Guide
Install the new ribbon:
With the ribbon to the outside,
place the right spool on the
right hub. Press down on the
spool until the hub latch snaps
in place.
Thread the ribbon around
the ribbon guide and along
the ribbon path. (Refer to
the ribbon path diagram on
the shuttle cover.) Be sure
to thread the ribbon
between the hammer bank
cover and the ribbon mask.
The ribbon must not be twisted. A twisted
ribbon can lower print quality, shorten
ribbon life, or cause paper jams.
Place the left spool on the left hub.
Press down on the spool until the
hub latch snaps into place.
Hand–turn the right spool to make
sure the ribbon tracks correctly in
the path and ribbon guides.
Ribbon
Guide
Ribbon
Mask
Hub
Latch
Hammer
Bank
Cover
Summary of Contents for LG plus Series
Page 8: ...ii Table of Contents...
Page 26: ...18 Operator s Guide...
Page 62: ...54 Operator s Guide...
