Fault Messages
64
Operator’s Guide
When a fault condition occurs, the status lamps
flash, the alarm sounds, and a specific message
appears in the display. When this happens,
correct the fault immediately.
You can correct most faults by performing a
simple procedure, such as clearing a paper jam
or reloading paper. The following pages list
common fault messages and explain how to
correct the fault conditions.
For more serious faults, indicated by an asterisk
(*) following the fault message, a Digital
Customer Service Engineer may be needed.
Perform the following steps to clear a fault
message after you have corrected the fault
condition,
and before you call a Digital Customer
Service Engineer for the faults indicated by an
asterisk (*):
Press CLEAR, then ON LINE to
continue printing.
If the fault message reappears, turn
the printer power off, wait 15 seconds,
then turn the printer back on. Run your
print job again. If the message does
not reappear during printing, no further
attention is required. If the fault
message reappears, go to step 3.
Press CLEAR, then ON LINE again
and resume printing. If the message
does not appear, no further attention is
required. If the message reappears,
call your Digital Customer Service
Engineer.
Summary of Contents for LG plus Series
Page 8: ...ii Table of Contents...
Page 26: ...18 Operator s Guide...
Page 62: ...54 Operator s Guide...
