9
1st Edition, April 1993
Setting Top–of–Form
1. Press the ON LINE switch to place the printer off–line and open the printer cover.
2. Make sure several sheets of paper extend past the tractors. If necessary, press the FF switch twice to
feed a couple of sheets beyond the tractors and into the paper guide assembly.
3. Fully raise the forms thickness adjustment lever (A). You will hear a beep, indicating that a fault
condition exists.
4. Rotate the vertical position knob (B) to set the center of the first printable line at the top–of–form
indicator (C) on the left tractor gate.
5. Set the forms thickness adjustment lever (A) to match the paper thickness you are using. (The A–B–C
scale corresponds approximately to 1–, 3–, and 6–part paper thickness. Adjust until you have the
desired print quality.) The fault condition clears automatically.
6. Press and release the SET TOF switch. The paper reverse feeds to the print position.
7. Close the printer cover.
8. Press the ON LINE switch to place the printer on–line.
