Table 7–6:
Reset State Default Parameters
Selectable
Parameter
Reset Default Condition
Print Status
On-line (ready)
Horizontal Pitch
10 characters per 2.54 cm/in
Vertical Pitch
6 lines per inch
Font
Data Processing
Forms Length
66 lines (11 inches/27.94 cm)
Active Position
Column 1 on the current active line (line 1)
Top Margin
Line 1
Bottom Margin
Line 66
Left Margin
Column 1
Right Margin
Column 132
Underlining
Disabled
Bolding
Disabled
Italics
Disabled
Character
Expansion
Disabled
GL Character Set
U.S. ASCII or the last NCR if selected
GR Character Set
Digital Supplemental
G0 Character Set
U.S. ASCII or the last NCR if selected
G1 Character Set
VT100 Graphic Character Set
G2 Character Set
Digital Supplemental
G3 Character Set
U.S. ASCII
Autowrap
Enabled
Line Feed/New
Line Mode
Set
Horizontal tabs
At every 8 columns (9, 17,..137)
Unsolicited reports
Disabled
Super/Subscripts
Disabled
Carriage Return
New Line Mode
Reset
Vertical Tabs
Every line (1, 2, ... 66)
The following will not change:
All Interface settings
The National Replacement Character Set
Top and bottom margins
Left and right margins
These parameters will remain as previously selected, either by escape sequence
or control panel.
OPERATOR MAINTENANCE
7–9