Installing the Firmware
Installation
Procedure
To install the ROM chips:
1.
Disconnect the power cord from the wall outlet and then from
the rear panel.
2.
Open the operator panel cover ( ).
3.
Loosen the two captive screws from the card cage cover and
remove the cover (
).
4.
Loosen the two captive screws securing the grounding bracket
and remove the bracket (
).
1
3
2
2
5.
Pull open the release handles on each side of the controller
board ( ) and remove the board (
).
1
2
2
Summary of Contents for PrintServer 32
Page 6: ......
