EK–SMRAA-IG. A01
ix
Getting Started
This section provides an overview for preparing and installing the RAID Array 310 for Windows NT in your Intel-
based system. Detailed information is contained in Chapters 1 through 5.
Thank you for purchasing a StorageWorks RAID Array 310 Subsystem. You should have re-
ceived the following:
•
StorageWorks RAID Array 310 Manager for Windows NT platform kit
•
StorageWorks RAID Array 310 Subsystem (SWXRA-Yx)
Note
Installing the StorageWorks RAID Array 310 Subsystem requires a
technical understanding of the following:
•
Intel-based Computer System
•
RAID array concepts
•
Windows NT
•
Basic hardware installation procedures
•
Or, contact your supplier or service representative for installation
assistance.
The major steps for installing and setting up the StorageWorks RAID Array 310 Subsystem
include the following:
1. Performing the pre-installation steps listed below.
2. Unpacking the RAID 310 Deskside Subsystem. (Chapter 1)
3. Unpacking and installing one of the following host adapters in your computer system and
connecting it to the RAID controller:
•
Adaptec Model 2744W for Intel-based EISA systems (Chapter 2)
•
Adaptec Model 2944W for Intel-based PCI systems (Chapter 2)
4. Installing the RAID Array 310 Manager for Windows NT (Chapter 3)
5. Configuring the communications port settings (Chapter 3)
6. Creating an Initial Configuration (Chapter 3)
7. Completing the Installation under Windows NT (Chapter 4)