Single-Ended I/O Modules
UltraSCSI RAID Enclosure 5–19
Replacing an I/O Module
Complete the procedure in Table 5–9 to remove I/O modules. Complete the
procedure in Table 5–10 to install I/O modules when assembling an
enclosure or replacing an individual module.
___________________ Caution _____________________
To prevent interrupting a data transfer or losing data, shut down
the subsystem before removing an I/O module.
________________________________________________
Table 5–9 Removing an I/O Module
1. Shut down the array controller (see Table 5–10).
Use a screwdriver to loosen the two, spring-loaded mounting screws
on the I/O module.
2. Grasp the module by the cable support bracket and pull it directly to
the rear and remove it from the enclosure shroud.
CXO5940A
3. Cut the wire tie on the left cable. Loosen the thumb screws and
remove the cable.
4. Label the cable connector.
5. Cut the wire tie on the right cable. Loosen the thumb screws and
remove the cable.
6. Label the cable connector.
___________________ Caution _____________________
Overtightening the I/O module spring-loaded mounting screws
can damage the threads.
________________________________________________
Summary of Contents for StorageWorks UltraSCSI DS-BA370 Series
