Single-Ended I/O Modules
5–20 UltraSCSI RAID Enclosure
Table 5–10 Installing an I/O Module
1. Remove the I/O module from the shipping container and verify that
it is a model DS–BA35X–MN.
2. Align the left cable with the I/O module connector.
3. Gently insert the cable connector into module connector. Tighten
both cable connector thumb screws to fully seat the connector.
CXO5940A
4. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
5. Align the right cable with the I/O module connector.
6. Gently insert the cable connector into module connector. Tighten
both cable connector thumb screws to fully seat the connector.
7. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
8. Align the I/O module with the backplane connector in the enclosure
shroud. Gently insert the module and fully seat it. Use a screwdriver
to tighten the spring-loaded mounting screws.
9. Turn on the subsystem and verify that it is operating properly.
Summary of Contents for StorageWorks UltraSCSI DS-BA370 Series
