Single-Ended I/O Modules
5–22 UltraSCSI RAID Enclosure
Table 5–11 Removing an Expansion Cable
1. Shut down the array controller (Table 5–5).
Use a screwdriver to loosen the two, spring-loaded mounting screws
on the I/O module.
2. Grasp the module by the cable support bracket and pull it directly to
the rear and remove it from the enclosure shroud.
3. Repeat Steps 1 and 2 for the other I/O module.
4. Cut the wire tie on the left cable. Loosen the thumb screws and
remove the cable.
CXO5940A
5. Label the cable connector.
6. Cut the wire tie on the right cable. Loosen the thumb screws and
remove the cable.
7. Label the cable connector.
____________________ Caution ____________________
Overtightening the I/O module spring-loaded mounting screws
can damage the threads.
________________________________________________
Summary of Contents for StorageWorks UltraSCSI DS-BA370 Series
