Power Distribution
6–12 UltraSCSI RAID Enclosure
Table 6–2 Removing a Power Supply
1. To perform a hot swap go to Step 3.
2. To perform a cold swap, turn off the ac power controller.
3. Disconnect the power cord from the front of the SBB.
4. Press the two mounting tabs together to release the power supply
from the shelf.
CXO-4314A-MC
5. Use both hands and pull the power supply out of the shelf.
6. Insert the power supply into an electrostatic shipping container.
7. Lay the supply on a flat surface.
8. Insert the shelf power supply into the guide slots and push it in to
fully seat it and the bezel mounting tabs engage the shelf.
9. Connect the power cord to the shelf power supply.
10. Both status LEDs should be O
N
.
Summary of Contents for StorageWorks UltraSCSI DS-BA370 Series
