Assembling an UltraSCSI RAID Enclosure
UltraSCSI RAID Enclosure B–9
Installing Controller “B”
The following procedure describes the mechanical procedures for installing
an array controller and a cache module. You must configure the subsystem
using the procedures in the following publications:
•
the array controller documentation
•
The operating system-specific release notes.
Controller B Installation
1. Complete the sequential installation of the following UltraSCSI
enclosure components:
a) Power controllers and power supplies
b) EMU
c) PVA
d) Disk
Drives
e) I/O
Modules
f) UltraSCSI expansion cables
g) Controller
“B”
2. Remove the blank panels from the controller B and cache module B
positions.
Align controller “B” with the lower controller slot (device
address 6).
17
11
CXO5812A
19 20
21 22 23 24
13 14
15 16
18
7
8
9
10
12
1
2
3
4
5
6
Controller A
Controller B
EMU
PVA
Cache B
Cache A
Power
bus A
Power
bus B
A
B
4A
3A
2A
1A
3B
2B
1B
4B
Shelf 4
Shelf 3
Shelf 2
Shelf 1
Summary of Contents for StorageWorks UltraSCSI DS-BA370 Series
