Operating the UltraSCSI Enclosure
2–18 Ultra SCSI RAID Enclosure
SBB Shelf Status
The two green LEDs on each power supply (see Figure 2–5) display the
blower, the power bus, and the individual power supply status. Normally,
both these LEDs are O
N
.
The shelf status LED is O
N
when all the power supplies and all the blowers
are operational. When any blower or power supply fails, this LED is
O
FF
.
Figure 2–5 Shelf Status LEDs
CXO-4787A-MC
Shelf
status LED
(Green)
Power supply
status LED
(Green)
The power supply status LED
is O
N
when the power supply is operating
properly
For detailed information about the power supply status LEDs, see Chapter
6, “Power Distribution.”
SBB Configuration
Part of the initial configuration procedure for the subsystem involves
configuring the disk drives so that the array controllers know the device
type, physical location, and logical location. This information is the basis
for the array controller transferring data blocks to specific disks to create
storage sets. Once the configuration process is complete, the system cannot
function properly unless all the disks remain in the same physical and
logical location.
The enclosure automatically notifies the array controller of the removal of a
device. This ensures that the array controller can implement the following
actions.
Summary of Contents for StorageWorks UltraSCSI DS-BA370 Series
