3–12
Removing and Replacing FRUs
6.
Disconnect the 6-wire, 9-pin braided CRT/yoke cable (P11) on
the deflection module by pressing the tabs on the connector (J11)
(Figure 3–10).
7.
Disconnect the 9-wire, 9-pin raster control cable (P6) on the deflection
module by pressing the tab on top of the connector (J6).
1
2
1
2
M A - 1 2 2 9 - 8 9 . D G
D e f l e c t i o n M o d u l e
6 - W i r e , 9 - P i n ,
C R T / Y o k e C a b l e
9 - W i r e , 9 - P i n ,
R a s t e r C o n t r o l
C a b l e
Figure 3–10
Disconnecting Cables from the Deflection Module