38
Y.M.C
O.D. = 1.9
Y.M.C
O.D. = 2.1
Input
Output
Input
Output
Input
Output
[High]
[Standard]
[Low]
When black omitted characters
are to be put out with high
density
Setting at the time of shipping
from the factory
When changed to close to the
hue of a CRT
C
M
Y
2.2.6 Device Type Setting
The device type of SCSI Standerd is switched. Normally
"Printer" is used.
2.2.7 Card Fan Setting
At the time of separating the card and the retransfer film,
the card is cooled with a fan. Depending on the card, the
transfer may be better when there is no cooling. In such a
case, change this setting.
2.2.8 TUR Response Setting
This mode selects the response that the printer returns to
the "Test unit ready" command from the host computer
while the printer is executing printing. Normally the set-
ting is changed according to the application software on
the side of the host computer.
2.2.9 Compatible Mode Setting
This mode is set when application software created for
the model CX710 is to be used with the XID580i. How-
ever, care is required as the compatibility is not perfect.
2.2.10 Setting of the ink-sensor level
Set the threshold level of the ink sensor so that the ink
sensor defect the ink color “yellow” and “magenta” as trans-
mission, and “cyan” and “Bk”as interruption. Select thresh-
old value by using “
↑
” and “
↓
” buttons, and press the “EN-
TER” button to save the select Value.
Select “User’s LUT” when the print density similar to that of CX710 is needed.
2.2.3 Offset Trf X Setting
1) Determine the displacement amount according to
the print results (those owned by the user). Every
step corresponds to a displacement of about 0.17
mm. The step can be varied in the range between -
7 and +7.
2) Press ENTER to save the setting.
3) Print and check the result.
4) To adjust to the standard setting:
In the service mode, print color patterns on single
sides of 4 to 5 cards.
Adjust so that the distance from the card edge to
the box enclosing the line (A) is about 2.07 mm.
(Check the third to fifth cards.)
2.2.4 Card Stop Position Setting (Offset Card X)
This adjustment is made when special cards are used.
In the same way as in the preceding item, the card stop
position is adjusted and the transfer position is changed.
When standard cards are used, the cards may be flicked
out. Accordingly, this setting normally should not be
changed.
2.2.5 Default LUT Setting
When printing data with a high density are to be printed
over the entire area, wrinkles may be caused. In such a
case, switch the setting to “Standard” or “Low”.
