m
If download fails and printer cannot be started up
v
If download of the printer firmware fails, the printer may not be
able to start up when it is rebooted. When this occurs, download
the firmware again according the following procedure.
A
Turn on the power while holding down the operation button
(center)
v
A [SBP2 Running] message appears, indicating that the printer
is ready to download data from the computer.
.
B
Start data download from the computer
v
A [Downloading..] message appears.
v
A [SBP2 Running] message appears when data download from
the computer is complete.
C
When the [SBP2 Running] message appears, turn off the power
v
The firmware is updated after the power is turned on again.
Display Mode Setting
v
This is used for setting the information to be displayed on the
operation panel.
Settings
v
Counter:
Displays the counter preset in "Counter setting".
v
Laminator State:
Displays the operating status of the connected laminator. If a
laminator is not connected, the counter is displayed.
1
Press
I
v
A [Cleaning] message appears.
.
2
Press
J
to set to [Setting]
v
Pressing it each time displays the next setting item.
.
3
Press
G
v
A [Display] message appears.
.
4
Press
G
v
A [Mode] message appears.
.
5
Press
F
v
Enters the settings change mode.
.
6
Press
A
and select a setting
7
Press
B
to confirm the setting
v
Pressing
B
confirms the setting and returns you to the previous
screen.
8
Press
H
to exit the setting mode
v
Pressing it each time displays the setting item on the next higher level.
Operating the Printer
23
Summary of Contents for XID 8300
