Unit Number Setting
v
For setting the printer’s unit number according to the USB
environment.
Settings
v
No.1 - No.10
1
Press
I
v
A [Cleaning] message appears.
.
2
Press
J
to set to [Setting]
v
Pressing it each time displays the next setting item.
.
3
Press
G
v
A [Display] message appears.
.
4
Press
J
to set to [Unit No.]
v
Pressing it each time displays the next setting item.
.
5
Press
F
v
Enters the settings change mode.
.
6
Press
A
and select a setting
v
You can select the unit number from No. 1 to No. 10.
7
Press
B
to confirm the setting
v
Pressing
B
confirms the setting and returns you to the previous screen.
8
Press
H
to exit the setting mode
v
Pressing it each time displays the setting item on the next higher level.
9
Turn off the power
v
The changes to the setting will be reflected when you turn on the
power again.
Transport Mode Setting
v
When transporting or moving the printer, ensure that the heating
roller is fastened to a safe position.
Cautions:
v
Make sure that you set to the transport mode when transporting or
moving the printer. Failure to do so will cause the printer to
malfunction.
1
Open the printer door
.
2
Press and hold down the cassette button, and remove the ink ribbon
cassette (on the right) to remove the ink ribbon
.
3
Press and hold down the cassette button, and remove the retransfer film
cassette (on the left) to remove the retransfer film
.
4
Close the printer door
Operating the Printer
27
Summary of Contents for XID 8300
