m
If the card is caught in the card feed roller to the left of the
retransfer heating roller
A
Turn off the power
B
Check the position of the card
C
Attach the jog dial to the card feed roller shaft
.
.
D
Turn the card feed roller shaft in the anti-clockwise direction,
while checking the position of the card
.
v
The card is discharged from the card outlet.
Cautions:
v
If the card cannot be removed, do not try to do so forcibly.
Consult our authorized dealers or the servicing personnel.
E
Restore the jog dial to its original position
F
Install the retransfer film cassette, and close the printer door
G
Turn on the power
Ink Ribbon
Ink Ribbon has Run Out
v
"Replace with a new ink ribbon." (
Ink Ribbon is Broken
v
Repair the ink ribbon.
Cautions:
v
If the security lock function is turned on, turn off the function from the
computer to unlock the printer. After closing the door, turn on the function
again from the computer.
v
Stand the cassette on a flat surface as illustrated in the diagram. Avoid
doing so on the floor as dust attached to it may cause printing errors.
.
v
Do not touch the inked surface (the side that faces outward when installed)
with your hand. Touching it may cause printing errors. Put on the supplied
gloves when handling the ink ribbon.
v
The cassette is heavy when the ink ribbon is loaded. To prevent the cassette
from dropping during handling, make sure to hold it with both hands.
v
When installing a used ink ribbon, align the yellow side of the unused ribbon
with the arrow indicated on the label of the cassette. If the position of the
yellow side is not properly aligned, the print may turn out light.
v
Do not perform any work on the printer door. Do not place heavy objects or
apply load on the printer. Doing so may damage it.
v
During replacement, clean the four bobbin holders on the printer. If burrs
produced by friction with the bobbins are attached to the bobbin holders,
they may fall onto the card, ink ribbon, or retransfer film, causing printing
errors.
"Cleaning the bobbin holders" (
1
Open the printer door
.
2
Press and hold down the cassette button, and remove the ink ribbon
cassette (on the right)
.
3
Cut away the broken portion, and attach the unused portion at the
supply side to the other end at the take-up side using an adhesive
tape, while making sure that the joint surface is even
Cautions:
v
Do not discard the used ribbon at the take-up side.
Troubleshooting
52
Summary of Contents for XID 8300
