Retransfer Film
Retransfer Film has Run Out
v
"Replace with a new retransfer film." (
Retransfer Film is Broken
v
Repair the retransfer film.
Cautions:
v
If the security lock function is turned on, turn off the function from the
computer to unlock the printer. After closing the door, turn on the
function again from the computer.
v
Stand the cassette on a flat surface as illustrated in the diagram. Avoid
doing so on the floor as dust attached to it may cause printing errors.
.
v
Do not touch the retransfer face (the side that faces outward when
installed) with your hand. Touching it may cause printing errors. Put on
the supplied gloves when handling the retransfer film.
v
The cassette is heavy when the retransfer film is loaded. To prevent the
cassette from dropping during handling, make sure to hold it with both
hands.
v
When installing a used retransfer film, align the unused side of the film
with the arrow indicated on the label of the cassette. Improper alignment
may result in errors, or the print may turn out light.
v
Do not perform any work on the printer door. Do not place heavy objects
or apply load on the printer. Doing so may damage it.
v
During replacement, clean the four bobbin holders on the printer. If burrs
produced by friction with the bobbins are attached to the bobbin holders,
they may fall onto the card, ink ribbon, or retransfer film, causing printing
errors.
"Cleaning the bobbin holders" (
1
Open the printer door
.
2
Press and hold down the cassette button, and remove the retransfer
film cassette (on the left)
.
3
Cut away the broken portion, and attach the unused portion at the
supply side to the other end at the take-up side using an adhesive
tape, while making sure that the joint surface is even
Cautions:
v
Do not discard the used retransfer film at the take-up side.
4
Turn the take-up side using your hand until the broken portion can
no longer be seen
.
v
Align the film side of the unused portion with the arrow indicated on
the label of the cassette.
5
Remove any slack in the film
.
6
Insert the cassette all the way in along the guide rail until a “click”
sound is heard, followed by closing the printer door
.
.
Troubleshooting
54
Summary of Contents for XID 8300
