Digital Projection
E-Vision 8000 series
A TOUR OF THE MENUS
Operating Guide
Page Op_11
Rev A April 2012
Notes
See also
Using the Menus
, earlier
in this guide and
Menu Map
, later in
this guide.
Overscan is used to compensate
for noisy or badly defined image
edges, by cropping the image, or
increasing the size of the image to
force the edges off-screen.
Overscan
•
Set this to
Off
On
or
Zoom
as required.
VGA Setup sub menu
•
Press
ENTER
to open the VGA Setup sub menu.
Horizontal Total, Start and Phase, Vertical Start
•
Adjust the sliders for these settings, as required to suit the incoming image.
Auto Sync
•
Press
ENTER
to force the projector to re-synchronise with the input signal.
PICTURE Menu
continued
