Digital Projection
E-Vision 8000 series
A TOUR OF THE MENUS
Operating Guide
Page Op_15
Rev A April 2012
Notes
See also
Using the Menus
, earlier
in this guide and
Menu Map
, later in
this guide.
Only one of the Warp controls, or
the Blanking control can be used
at any one time.
Exception: all four Corner controls
can be used at the same time.
If the Edge Blend feature is in
use, then only the four Corner
controls can be used.
If you are not sure which Warp
control is in use, then select
Reset
,
from the
Warp
menu to reset all
controls to zero.
Warp sub menu
•
Press
ENTER
to open the Warp sub menu.
Keystone, Rotation, Pincushion/Barrel, Corner
•
Use
and
to select one of the warp controls.
•
Press
ENTER
to open the warp control box:
•
Use the
Keystone
control to correct for any distortion caused by the projector being
in a different horizontal or vertical plane to the screen..
•
Use the
Rotation
control to rotate the image up to 5° clockwise or anti-clockwise.
•
Use the
Pincushion/Barrel
control to correct for any distortion caused by the screen
being concave or convex.
•
Use the four
Corner
controls to stretch the image from each of the four corners..
•
Use
Custom Warp
to activate a user-defined warp pattern.
Reset
•
Press
ENTER
to reset all warp settings to zero.
Warp control boxes
ALIGNMENT Menu
continued
