Digital Projection
E-Vision 8000 series
A TOUR OF THE MENUS
Operating Guide
Page Op_16
Rev A April 2012
Notes
See also
Using the Menus
, earlier
in this guide and
Menu Map
, later in
this guide.
Only one of the Warp controls, or
the Blanking control can be used
at any one time.
Exception: all four Corner controls
can be used at the same time.
If the Edge Blend feature is in
use, then only the four Corner
controls can be used.
If you are not sure which Warp
control is in use, then select
Reset
,
from the
Warp
menu to reset all
controls to zero.
Blanking sub menu
•
Press
ENTER
to open the Blanking sub menu.
Top, Bottom, Left and Right
•
Set each slider as required.
Reset
•
Press
ENTER
to reset all blanking settings to zero.
ALIGNMENT Menu
continued
