page 5.4 105-681B January 2007
5. Maintenance
Digital Projection
LIGHTNING 30sx+m, 40sx+m
User Manual
To change the lamp:
•
Press the
LAMP
button on the
Main menu
.
•
Press
LAMP OFF
and hold for 3 seconds. The lamp will ramp down to minimum
and go off after a further 3 seconds.
•
Allow the lamp to cool for 5 minutes.
•
Push the main power switch downwards to switch off the power.
•
Open the lamp compartment door.
•
Unscrew each of the three lamp module screws until the thread disengages and
the knob can be pulled out a little against its spring pressure.
•
Pull the lamp module out of the projector.
To fit the new lamp module:
•
Rest the lamp module on the edge of the compartment and line up the white
nylon guides.
•
Gently but firmly, push the lamp module in all the way until the connector
engages.
•
Screw in each of the three lamp module screws until finger tight.
•
Push the lamp compartment door closed.
Notes
Take care when removing the
lamp module, as it is heavy
(>10kg).
Take care not to touch the
glass surface of the lamp
module. If you do accidentally
touch the glass, it should be
cleaned before use.
Lamp module
screws