DL-SE3H1V-C Owners Manual
9
L
R
L
R
AUDIO
SOURCE
DL-SE3H1V-C
Connecting a Display
HDMI Output
Connect the display devices to HDMI output on the receiver using an HDMI cable that is less than or equal to
5 meters in length. For display devices that are further away, it is highly recommended to utilize the HDBaseT
output.
TIA/EIA-568B
Orange/White
Orange
Green/White
Blue
Blue/White
Green
Brown/White
Brown
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
1
8
Connect a category cable to the transmitter and the HDBaseT receiver.
HDBaseT Output
Connect Audio Output
Insert the removable 3-pin phoenix connector block to the audio output. The DL-SE341V-C supports a stereo
unbalanced output
Twisted Pair Wiring
Use TIA/EIA-568B wiring for Category 6
connection between the transmitter and
receiver
To ensure proper performance of the DL-SE3H1V-C, it is recommended that you use solid core
shielded Category 6 F/UTP cabling at a minimum. Category 5e F/UTP may perform well but
may not support power over HDBaseT reliably.
For optimized performance use the following Liberty Wire and Cable branded cabling;
Category 6 plenum;
24-4P-P-L6SH
Category 6A plenum;
24-4P-P-L6ASH
Category 6 NON-plenum;
24-4P-L6SH
Category 6A NON -plenum;
24-4P-L6ASH
When using shielded category cabling ALWAYS...
....use shielded connectors
....properly ground the category cable
