The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely con
fi
dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
48
IR SENSOR FO R PASSENGER DETECTION
310
Distance to enable registra on or ForHire
: this is the distance that enables either the registra on of the black fare with a passenger aboard in
Stopped or the automa c ac va on of Hired. See Q.313. The distance is given in metres with an accuracy of 0.1 meter. The allowed value goes
from 0.0 (min) to 6553.5 (max). The digit indica ng mul ples of 0.1 m (so at the right of the decimal point) will
fl
ash.
0 - 65535
311
IR-sensor for passenger-det. is present?
- Is the Infra-Red-sensor for the detec on of passengers present?
The allowed answer is either: 0 (No: not present) or: 1 (Yes: present).
No / Yes
312
IR-sensor contact is normally closed?
- Is the Infra-Red-sensor contact a Normally Closed contact ? If not, then it is a Normally Open contact.
The allowed answer is either: 0 (No: normally open) or: 1 (Yes: normally closed).
0=open
1=closed
313
Black fare registr. or autom. in Hired?
- A er the distance programmed in Q.310 should be ac vated either: the registra on in memory
of the black fare with a passenger aboard in Stopped or the automa c ac va on of Hired?
The allowed answer is either: 0 (No: registra on) or: 1 (Yes: pass to Hired).
0 = registra on
1 = pass to Hired
314
Block taximeter if fare-memory is full?
- Should the taximeter be blocked when the fare-memory is full?
The allowed answer is either: 0 (No: don’t block) or: 1 (Yes: block).
No / Yes
315
The ForHire led
fl
ashes if IR-sensor is ON?
- When the IR-sensor is ac vated should the ForHire led
fl
ash?
The allowed answer is either: 0 (No: don’t
fl
ash) or: 1 (Yes:
fl
ash).
No / Yes
from Q 316
/ Available for any possible so ware extension /
to Q 318
STATISTICAL M EMORY BLOCK N.1
319
Inhibit visualiza on memory-block n. 1?
- Should it be impossible to visualize memory-block number 1? See also Q.320.
The allowed answer is either: 0 (No: visualize) or: 1 (Yes: inhibit).
No / Yes
320
Enable visualiza on MB1 with password?
- If the visualiza on of memory-block number 1 has been inhibited (see Q.319) should it be possible
to undo this with the password? The allowed answer is either: 0 (No: keep inhibited) or: 1 (Yes: enable with password).
No / Yes
321
Inhibit prin ng memory-block n. 1?
- Should it be impossible to print memory-block number 1? See also Q.322.
The allowed answer is either: 0 (No: print) or: 1 (Yes: inhibit).
No / Yes
322
Enable prin ng MB1 with password?
- If the prin ng of memory-block number 1 has been inhibited (see Q.321) should it be possible to undo
this with the password? The allowed answer is either: 0 (No: keep inhibited) or: 1 (Yes: enable with password).
No / Yes
323
Inhibit reset of memory-block n. 1?
- Should it be impossible to reset memory-block number 1 from panel? See also Q.324.
The allowed answer is either: 0 (No: reset from panel) or: 1 (Yes: inhibit).
No / Yes
324
Enable reset of MB1 with password?
- If the reset from panel of memory-block number 1 has been inhibited (see Q.323) should it be possible
to undo this with the password?
The allowed answer is either: 0 (No: keep inhibited) or: 1 (Yes: enable with password).
No / Yes
325
Inhibit access to stat. Memory n. 1?
- Should it be impossible to have access to the reading-procedure of the sta s cs-memory number 1?
The allowed answer is either: 0 (No: access) or: 1 (Yes: no access).
No / Yes
ACCESS TO TARI FF PROGRAMMING
326
Programming only with the memory-key?
- Should programming only be possible with the memory-key? If not, then programming is also
possible step by step. The allowed answer is either: 0 (No: also step by step) or: 1 (Yes: only memory-key).
No / Yes
STATISTICAL MEM ORY BLOCK N. 2
327
Inhibit visualiza on memory-block n. 2?
- Should it be impossible to visualize memory-block number 2? See also Q.328.
The allowed answer is either: 0 (No: visualize) or: 1 (Yes: inhibit).
No / Yes
328
Enable visualiza on MB2 with password?
- If the visualiza on of memory-block number 2 has been inhibited (see Q.327) should it be possible
to undo this with the password? The allowed answer is either: 0 (No: keep inhibited) or: 1 (Yes: enable with password).
No / Yes
Summary of Contents for M1 mdt
Page 1: ...Technical Manual InstallationandProgramming ver 1 16 12 2014...
Page 2: ......
Page 83: ......
