15
Applying Power
Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the
steps listed below.
1. Turn the amp volume all the way down.
2. Connect the plug of the PS0913B power supply to the power jack on the rear panel of the
RP255.
3. Connect the other end of the PS0913B power supply to an AC outlet. Turn the RP255’s Mas-
ter Level knob (Knob 4) down to “0”.
4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal
playing level.
5. Gradually increase the RP255’s Master Level knob to achieve the desired volume.
4. Turn amp volume up
1. Turn amp volume down
2. Connect PS0913B to power jack
3. Connect PS0913B to AC outlet
and turn the RP255’s Master
Level to “0”
5. Turn the RP255’s Master Level to the
desired listening volume
Summary of Contents for RP255
