11
Headphones
Connect a pair of stereo headphones to this 1/8" jack. For proper frequency response,
the Amp/Mixer switch should be set to Mixer (“in” position) when using headphones.
Headphones with an impedance of 100 Ohms or less are recommended.
Note:
The Headphones output can have either a mono or stereo signal, depending on what
1/4" outputs are connected. If neither (or both) 1/4" outputs are connected, the Headphones
output will be in stereo. If a cable is connected to the Left (Mono) 1/4" output only, the Head-
phones output will be in mono.
Power Input
Connect only the DigiTech
®
PS200R power supply to this jack.
4.
5.
Summary of Contents for RP90
Page 1: ...Modeling Guitar Processor Owner s Manual ...
Page 12: ... A GuidedTour of the RP90 Front Panel 1 2 3 4 5 7 8 9 6 ...
Page 18: ...12 ...
Page 47: ......