50
NOTE:
The
Minimum CC Value
and
Maximum CC
Value
Parameters allow you to limit the range of the continu-
ous controllers in the full on and full off positions. The values
you select on these two screens determine the behavior of the
continuous controller. For example, if a Parameter ranges
from 0-100 and
Minimum CC Value
is set at 40, the low-
est the Parameter can be set via continuous control is 40.
Likewise, if
Maximum CC Value
is set at 90, the CC range
would run from 40 to 90. It is also possible to set
Minimum
CC Value
higher than
Maximum CC Value
to reverse
the action (polarity) of the continuous controller.
• Use the <UP>/<DOWN> Cursor keys to set the minimum
Parameter value when the continuous controller is at minimum.
• Press the <RIGHT> Cursor key once. The display reads:
The number shown with this Parameter automatically defaults to
the maximum Parameter value).
• Use the <UP>/<DOWN> Cursor keys to set the maximum
Parameter value when the continuous controller is at maximum.
• Press the <UTILITY> Cursor key once to return to Parameter in
the Program. Note that the CC symbol appears in the upper
right corner of the display. This symbol simply tells you that the
Parameter is linked to a continuous controller.
At this point, you have successfully assigned CC Link #1 to a
Parameter and a specific continuous controller number. When you
move your CC transmitting device (such as the internal pedal of the
optional Control One foot controller), the Valve FX sweeps smoothly
between the two values you selected (minimum, maximum). The
Program must now be saved or the CC Link assignment will be lost
upon changing Programs (see Storing / Naming Programs, pg. 17).
NOTE:
In order for the Valve FX to respond to incoming CCs, the
Valve FX
MIDI Channel
setting must match the channel of the
incoming messages. The Valve FX
MIDI Channel
can be set
to any one of the 16 MIDI channels, or all channels (omni).
Maximum CC Value
≤[PARAM VALUE]
Section 5 - The Utility Menu
Valve FX Owner’s Manual
