© 2021 Digitrax, Inc.
www.digitrax.com
— 8 —
8.0 Warranty & Repair
Digitrax gives a one year Warranty against material and manufacturing defects
on the DS78V.
Visit www.digitrax.com for instructions for
returning items for repair. Please return
warranty items directly to Digitrax -
DO NOT return items to place of purchase.
Digitrax, Inc. reserves the right to make changes
in design and specifications, and/or to make addi-
tions or improvements in its products without im-
posing any obligations upon itself to install these
changes, additions or improvements on products
previously manufactured. IPL capable products
like the DS78V & DT602 may be user updated
with the latest IPL files that are available for free
on the product specific information pages of the
www.digitrax.com web site. The newest features
are documented on the product pages of the
website.
Digitrax, Inc. is not responsible for unintentional
errors or omissions in this document.
ally each control 8 individual OPSW bits. OPSW1 is ls bit of CV11, through
OPSW8, as ms bit of CV11.
5. The DT602 does not indicate to the DS78V when programming is complete.
After finishing CV changes, best practice is to POWER cycle the DS78V to
save changes. Alternately, you can WRITE CV7 to 00 to restart that DS78V.
7.0 Set up Notes:
1. The DS78V manages servo supply voltages at 5V.
2. In all output modes a 300mA /12 to 14V DC supply should suffice.
3. Using DigiIPL II version 2.9.1 or later on a PC will display a Sub-version
number that confirms the last downloaded IPL/update#, since the DS78V
does not have a LCD display to show this last IPL download info
4. The OTA and OTB screw terminals are connected to TKA and TKB wires and
allow DCC track feed wires to daisy-chain between multiple DS78V's.
5. A connected DSXCP1 will flash red/green while its servo is moving.
Regulatory Information
Declaration of Conformity: “This device complies with part 15 of the
FCC Rules for a Class B digital device. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.”
These limits are designed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one of the following measures: Reorient or relocate the receiving antenna. Increase the
separation between the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or an experienced radio/
TV technician for help
307-DS78V
-0000
2443 Transmitter Road
Panama City, FL 32404
www.digitrax.com
Need Support?
helpdesk.digitrax.com
Made in the USA
