EPO Input
Polarity
setting (8)
①
Enter the setting interface. Press and hold the function
setting key
for more than 2 seconds, then come to setting
interface, Press and hold the scroll key
for more than
half a second(less than 2 seconds), select the
function
setting, choose EPO Input polarity setting
interface
, the
letters “EPO” will flash.
②
Enter the EPO Input Polarity setting interface. Press and
hold the function setting key
for more than half a
second(less than 2 seconds); the letters “EPO” will stop
flashing. The letters below the “EPO” will flash. Press and
hold the scroll key
for more than half a second (less than
2 seconds), select the EPO input polarity, “+P”(open circuit
execute EPO function) or “–P”(short circuit execute EPO
function)
③
Confirm the setting. After selecting EPO input polarity,
press and hold the function setting key
for more than half
a second (less than 2 seconds). Now, the setting is
confirmed.
④
Exit from the setting interface.Press and hold function
setting key
for more than half a second (less than
2 seconds), exit from the setting interface and return to
main interface.
(Battery) End of
discharge
setting (9)
①
Enter the setting interface. Press and hold the function
setting key
for more than 2 seconds, then come to setting
interface , short press the scroll key
for more than half a
second (less than 2 seconds) to select Eod setting, the letters
“Eod” will flash.
②
Enter the Eod setting interface. Press and hold the function
setting key
for more than half a second(less than
2 seconds) at this time, the letters “Eod” will stop flashing.
③
Set the Eod tolerance range. Short press the scroll key
or
for more than half a second (shorter than 2 seconds) to
select the voltage range in percentage. 10.0V, 10.5V, 11.0V
(default is 10.0V), then short press function setting key
for more than half a second (shorter than 2 seconds)to
confirm the selection, then to set the minus range
