I/O Terminal Block
This camera supports external I/O device connection, and an I/O terminal block is supplied with this camera for easy connection.
Below shows which input on the I/O terminal block you should use for wiring when you want to connect an external device to this camera.
3-pin I/O Terminal block
4-pin I/O Terminal block
Example of Alarm Out Connection
d
CAMERA CONFIGURATION
For advanced configuration of your DIGITUS camera with
DIGITUS NVR, please refer to below for the connection:
Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.
Step2: Install the “IPScan.exe” from the CD on your computer and use this utility to find the IP address of the camera.
Step3: After searching, set your PC in the same network segment as the specific camera you want to access, such as
“192.168.30.xxx” (xxx could be 0~255) in our example
Step4: Note down the IP address and port number of the camera you want to access, such as “192.168.30.1” and “88” in our
example.
Step5: Open Internet Explorer on the PC, and enter the IP address and port number in the URL column to access the camera. The format is
http://ipaddress:portnum, such as
http://192.168.30.1:88
in our example.
