background image

 

External infrared illuminator, 

60m/50m/30m 

 

Manual 

DN-16101 

 DN-16102 

 DN-16103 

 

The external infrared spotlight improves the night vision function of available 

cameras over a distance of up to 50 meters. Objects within the camera range can 

thus be illuminated and recognized more clearly at night. The infrared spotlight has a 

beam angle of 30° and uses the 850nm band for infrared illumination. The strength 

of the illumination can be adjusted by means of the integrated light sensor, from 

which the infrared spotlight should come on stream. The spotlight is developed for 

use outdoors in accordance with the IP66 standard and can be operated within a 

temperature range of -20°C to 50°C. The intensity of the infrared spotlight can be 

adjusted by means of a knurled screw so that it does not lead to excessive 

illumination independent of the application during use. The spotlight is mounted by 

means of a u-beam. For the power supply, a 12V/DC power pack with an exterior 

diameter of 5.5mm and an inner diameter of 2.1mm and an external negative pole is 

required. 

Summary of Contents for DN-16101

Page 1: ...n be adjusted by means of the integrated light sensor from which the infrared spotlight should come on stream The spotlight is developed for use outdoors in accordance with the IP66 standard and can be operated within a temperature range of 20 C to 50 C The intensity of the infrared spotlight can be adjusted by means of a knurled screw so that it does not lead to excessive illumination independent...

Page 2: ...em authorities certification testing Package Content Infrared spotlight x 1 User Manual x 1 Technical Specifications Wavelength Infrared light 850nm Beam angle 15 30 45 Distance 60m 50m 30m Operate method Built in light sensor 10 lux 20 lux constant lighting customized Power supply DC 12V Power consumption DC 12V label with input voltage V and current A Cable length DC12 DC plug 5 5 2 1mm 45cm DC1...

Page 3: ...ne to avoid electric shock the outlet of power wire should be installed downward 4 Through the installation hole on the mounted bracket the product can be directly fixed on pole or surface by screws 5 Adjust the angle of product by unscrewing on bracket camera and illuminator should be installed to the same horizontal and vertical direction 6 Link power wires tightly and make it waterproof to avoi...

Page 4: ...st under the below mentioned manufacturer address Note If wrongly installed or improperly used in the living area the device can cause interference in radios and other electronic devices Appropriate use is when the device as far as feasible is operated with shielded connection cables with network products in addition to category 5 shielded cables and higher The device has been tested and falls wit...

Reviews: