From the Global Config mode, the operator may enter the following
configuration modes:
Interface Config Mode
Many features are enabled for a particular interface. The Interface commands
enable or modify the operation of an interface. In this mode, a physical port is
set up for a specific logical connection operation. The command prompt at this
level is:
Command Prompt: Switch(Interface <
port#
>)#
1.7.2.
User Mode commands
help
This command displays help information
Format
help
Mode
User Mode
?
This command displays help information
Format
help
Mode
User Mode
logout
This command is used to exit from the telnet
Format
logout
Mode
User Mode
ping
This command sends echo messages.
Format
ping <
A.B.C.D
>
Mode
User Mode
show
1) show port
This command displays port status.
Format
show port {<
port#
> | all}
Mode
User Mode
2) show network
This command displays switch IP configuration
Format
show network
Mode
User Mode
3) show system
This command displays system information.
Format
show system
Mode
User Mode
4) show port statistics
This command displays port statistics.
Format
show port statistics {<
port#
> | all}
Mode
User Mode
Layer 2/2+ Management Switch Series
13
