DIGITUS POE Web Smart Ethernet Switch
4
Figure 1 - Front Panel
10/100Mbps RJ-45 ports (1~24):
Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps. Each has a
corresponding 10/100Mbps LED.
10/100/1000Mbps RJ-45 ports (25T, 26T):
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps.
Each shares a corresponding LED with an associated SFP port.
SFP ports (25S, 26S):
Designed to install the SFP module. The Switch features two SFP transceiver slots that are
shared with two associated RJ45 ports. A SFP port and an associated RJ45 port are
referred to as “Combo” port, which means they cannot be used simultaneously, and only
SFP port work or only RJ45 port work at the same time.
Reset:
Keep the device powered on and push a paper clip into the hole. Press down the button for
about 2 seconds. The system restores the factory default settings.
1.3.2 Rear Panel
The rear panel of the Switch contains AC power connector shown as below.
Figure 2 - Rear Panel
AC Power Connector:
Power is supplied through an external AC power adapter. It supports AC 100 ~ 240V, 50 /
60Hz.
Grounding Terminal:
The Switch already comes with Lightning Protection Mechanism. You can also ground
the Switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
