Hardware Installation
General instructions for installing the card are provided below. Since
the design of system may vary, refer to your system’s reference
manual for further information, if needed.
1. Power off your notebook computer.
2. Insert the USB 2.0 CardBus Adapter into the Type II PC Card slot
of your notebook computer. Make sure it is inserted all the way in
for a solid connection.
3. Power on your notebook computer.
Driver Installation
For Windows
®
2000 / XP / Vista / Windows 7
Windows
®
2000 / XP / Vista / Windows 7 has built-in driver support for
this controller. Just install the board and Windows will automatically
detect and install the correct drivers for it. No additional driver is
necessary.
To Verify Windows
®
Installation
1. Right click
My Computer
, then click
Manage
. Click
Device Manager
.
2. Double click
Universal Serial Bus controllers
option.
-
USB Root Hub
(
USB 2.0 Root Hub
in Windows
®
2000)
-
USB Root Hub
-
USB Root Hub
- VIA Rev 5 or later USB Universal Host Controller
(VIA USB Universal Host Controller in Windows
®
2000)
- VIA Rev 5 or later USB Universal Host Controller
(VIA USB Universal Host Controller in Windows
®
2000)
- VIA USB Enhanced Host Controller.
