2
Install the sensor you would like to use into the KF16 port. The following use cases for each sensor
are as follows:
A.) 0.1 Torr CM - The 0.1 Torr Capacitance manometer is used as a standard from 0.1
Torr to 5 x 10-04 Torr
B.) The DCP 10 Torr Capacitance Manometer gauge- The DCP has an integral capacitance
manometer, and is used as a standard in the region of 10 Torr to 0.1 Torr
C.) 1000 Torr CM- The 1000 Torr Capacitance manometer is used as a standard for the
pressure/vacuum region from 1000 Torr to 10 Torr
D.) The DPP Quantum high vacuum gauge- The DPP employs an advanced pirani
technology, and is used for general and high vacuum measurement from 7.5 x 10^(-06)
Torr to 1000 Torr for clean, dry environments; and is used as a high vacuum
comparison device to validate pressures between 7.5x10^(-06) and 1 x 10^(-03) Torr.
NOTE : Setting up the DASH
To SELECT your desired sensor (the 0.1 Torr
CM , DCP, 1000 Torr CM, or DPP) power on
the DASH by pressing the PWR/ENT button,
then press the
↻
button to open the menu.
Use the ▲ / ▼ buttons to toggle to Device
Selection, then press PWR/ENT to select. Use
the ▲ / ▼ buttons to toggle to the desired
sensor, then press PWR/ENT to select
C a l i b r a t i o n
K I T
1020 Campus Drive, Morganville, NJ 07751 - Office contact:
732-765-0900 - sales@digivac.com - www.digivac.com
Quick Start Guide
Connect the
Bullseye DASH to
the sensor using
the appropriate
cable adapter
(DB15 for CM's,
DB9 for Quantum
Gauges) and
power on the
device to monitor
pressure.
3
4
