22
S
af
et
y P
re
ca
u
tio
n
s
• Use within an ambient temperature range of 5
℃
to 35
℃
(Temporary use at
36
℃
to 40
℃
is allowed), and humidity range of 35% to 90%. Using in extreme
hot or cold places exceeding the range may damage them resulting in loss of
waterproof/dustproof property.
• Extreme changes in temperature cause condensation. Wait until the main unit
reaches room temperature before you bring the product from a cold place into
a warm bathroom.
No special measures against condensation have been implemented in this
product.
* If condensation occurs inside the display, leave the product at room
temperature for a while until condensation is cleared.
• Test according to the possible use of the product was performed to confirm
that performance was satisfactory. However, proper operation of the product
in every possible condition during actual use is not guaranteed. Malfunctions
determined to be caused by mishandling by the customer are not covered by
the warranty, and a repair is charged.
■
Draining water after wetting the product
If you use the URBANO PROGRESSO main unit with water droplets on its surface,
water may remain on the microphone, make it temporarily hard to hear the sound of
the speaker, or wet your cloth or bag. And water may have gotten into the product
through gaps in the external connection jack etc. Follow the following steps to remove
water on the product.
1
Wipe water thoroughly on the
surface of the product with a
clean dry cloth without waste
textiles
2
Shake the product
①
Hold the product firmly and shake it in the direction of arrows until water does
not come out.
* When shaking the product, stay alert to your surroundings.
* Be careful not to have the product pop out, and hold it firmly to drain water.
Speaker side/Earpiece side:
20 times or more respectively
Microphone side: 20 times or more
respectively
②
Wipe drained water.
* The microphone and the speaker are particularly hard to drain water. Face
those parts down and press to wipe off.
③
Place the product on a dry towel or cloth and leave it at room temperature.
3
Press the product gently to
clean dry cloth without waste
textiles, and wipe off water
remained in the gaps in the
microphone, speaker, external
connection jack, etc.
4
Leave the product for one hour or more at room
temperature to dry after removing drained water
thoroughly
Even after you take these procedures, water may remain on the product. Do
not place the product near things that you do not want to wet.
Also, take care not to wet your clothes, bag, etc.