19
•
If the primer takes too much force to be seated and the Handle cannot be pushed fully
to the rear—STOP and inspect the case. The primer pocket may be damaged or could
have a crimped primer pocket or the Primer Cup may not be aligned properly with the
Shellplate.
•
Low resistance to seating a primer can indicate an enlarged primer pocket that may
not retain the primer. Discard this case.
•
Verify that the system feeds primers as follows:
•
Remove the plastic Follower Rod and unscrew the Magazine Cap.
•
Remove and verify the Magazine Tube is of the correct size/color--The blue tip for
small primers and the red tip for large primers.
Note:
Any primers left in the
Magazine Tube will fall out in the Magazine Shield Tube.
•
Install the Magazine Tube in the Magazine Shield. The tab on the plastic Magazine
Tip, red or blue, must be gently aligned with the slot down in the Primer Feed Body
Housing and then should slide down about a 1/4” more. Tighten the knurled
Magazine Cap just snug.
•
With the Operating Handle up in its at-rest position, manually take one primer that
you will be using and drop it anvil side up in the hole in the Magazine Cap as below:
•
Cycle the handle smoothly down and back up to the top of the stroke to the “at rest position.”
•
The primer should present itself in the Priming Station on top of the Primer Punch as shown below—
repeat this step 3 times--if successful proceed to the next step, if not, proceed to Primer Drop Alignment
Section 10.2.
Drop one primer in
Magazine Shield/Cap
Correct presentation
of primer—Single
primer drop test—
Primer ready to be
seated Station 2
Magazine Tip Alignment Tab
Tighten knurled
Magazine Cap
just snug
Magazine Cap fits over
end of Magazine Tube
Red Large Tip and Magazine Tube
Blue Small Tip and Magazine Tube
Summary of Contents for Square Deal B
