23
8.5.2
The Square Deal “B” is shipped with a Small and a Large Powder Charge Bar. The Small Bar is installed in the
Powder Measure. The Dillon Powder Measure uses Charge Bars that are specific to the range of powder dispensed
as shown below.
Note: The Powder Measure is only activated by a cartridge case pushing up on the Powder Funnel.
8.5.3
There are 3 adjustments required of the Automatic Powder Measure System:
•
1--Full horizontal travel of the Powder Bar--The Powder Charge Bar must be adjusted to achieve full
horizontal travel. Failure to do so will result in inconsistent powder charges.
•
2--Case mouth belling adjustment
•
3--Powder charge weight adjustment
8.5.4
Place an empty-sized case in Station 2 with no powder in the Powder Measure. Loosen the 10-24 Powder
Measure Clamp Socket Head Screw with a 5/32” Allen wrench and the Powder Measure Clamp Button Socket
Head Screw with a 1/8” Allen Wrench (see below). Cycle the Operating Handle fully down. Proper adjustment is
achieved with the Powder Bar reaching the end of its travel at the same time the Operating Handle reaches the
bottom of its stroke, as indicated by the Bellcrank Arm just touching the Powder Body as shown below. If the Bell
Flake Powder
⑯
-Large
Bar
PN20063
⑩
-Small
Bar
PN20062
⑮
-Extra
Small Bar
PN20780
Store Spacer
Bar Plug in
hole here
when not in
use
④
Spacer Bar Plug PN13921 and
③
Spacer Bar
PN13664 only used with Small and Extra Small
Bars
Ball Powder
Summary of Contents for Square Deal B
