36
Tighten the Toolhead to the Frame with three of the Toolhead Screws with a 5/32” Allen Wrench. Thread
the Depriming Assembly into Station #1 and tighten it against the Toolhead.
Insert the Powder Die into the Powder Die Clamp and thread the Powder Die into Station #2 on the
Toolhead leaving approximately nine threads above the Clamp. Tighten the Clamp down to the Toolhead
with the last Toolhead Screw. It may be necessary to spread the clamp with a flat screwdriver to thread the
Powder Die into the Toolhead.
Each Conversion Kits includes a Seating Stem for Round Nose and Flat Nose Bullets. A few Conversion Kits
will also include a Seat Stem for a Wad Cutter. Select the Seat Stem that best fits the nose of the bullet
being used. Install the adjustable Seat Stem by threading it into Station 3 of the Toolhead five turns down
as a starting point.
Round Nose
Seat Stem
Wad Cutter
Seat Stem-
(.38 Special)
Flat Nose
Seat Stem
Select the Stem that best fits
the nose of the bullet
Thread Stem into Station #3 using the Bench Wrench or a
9/16” Wrench five turns down as a starting point
Install three
10-24 SHCS
Toolhead
Screws
Thread the Depriming Assembly flush against the Toolhead using
the Square Deal Bench Wrench or a 9/16” Wrench
Tighten Clamp down
to the Toolhead
Thread Powder Die
into the Toolhead
Thread Powder Die into
Toolhead—leave nine
threads above the
Clamp as a starting point
Put Powder Funnel
into Powder Die
Screwdriver blade
spreading Clamp if
necessary
Summary of Contents for Square Deal B
