❖Massage code
Contents display : 【 Feed Length （＿Release Mode) 】, Code number : 【 Feed Angle SPM 】
Emergency stop switch ON
Emergency stop switch OFF
Input stop signal release
Turn on Reset switch
Input stop signal
Automatic reset
EnD
Work shortage sensor ON
EnD_2
EnD
EnD_2
Interfere releasing
Turn on "Reset" switch
Input feed signal during feeding
Input feed signal during releasing
Input release signal during feeding
O_run
Overrun
❖Caution display
This caution displays have a possibility which the feeder is reset. These displays are as the follows,
Reset : Blinking. Feed Angle SPM :
C.
Number
Code
C.
40
Open phase
Confirmation of the power supply
C.
41
Low voltage detection
Checking the voltage
C.
10 -1
C.
10 -2
C.
50 -1
C.
50 -2
C.
50 -3
Malfunction of Rotation sensor
Setting mistake
Motor connection anomaly
Initial setting mistake
Contact failure
Number
State / Content
Note
Setting mistake of the motor
capacity
J06
After releasing the Emergency
stop switch, turn off the power.
Model
number
ENG
STOP
Turn on "Sync Feed" and "Sync
Release" after turn on "Reset"
switch
Turning off "Sync Feed", the work
shortage sensor will disabled.
I - F
7.7.7.7.7.7.
666666
Contents
CC - -
When turning on power only, the
control panel displays the program
Fｅｅｄ Length
-. -..].].
Feed Angle SPM
- - ] ]
Method of reset
Ins. Left, Direction Pull
Ins.Right, Direction Push
1.0.1.0.1.0.
662662
663663
777777
Another work shortage sensor release
Work shortage sensor release
Another work shortage sensor ON
Input stop signal during driving
press
1.1.1.1.1.1.
After setting a work pieces, turn
on "Reset" switch
Turn on Reset switch after input
stop signal release
664664
661661
Ins. Left, Direction Push
Ins.Right, Direction Pull
C. C. -. -.
4.4.4.4.4.4.
444444
101010
6
CS-0169
