Dimas Dimas WS 460, Operating Instructions Manual

Maintenance

In addition to the daily maintenance such as cleaning and
lubrication, the machine must be serviced.  After 50 hours 
of cutting, the wall saw should be serviced at an 
accredited Dimas workshop.  The saw should then be 
serviced after every 100 hours of operation. The service is
important so that as the user you have a machine that 
works as effectively as possible and for as long as possible.

Oil Change Cutting Arm

There is an oil plug for draining and filling the oil located
on the cutting arm.  This plug should be cleaned when
changing the oil.  The new oil is filled through the hole
where the oil plug sits.

The cutting arm contains 4 oz of Dimas Oil 150, a 
transmission oil of the type EP 150.  The oil should be 
replaced for the first time in connection with the first 
service and then twice a year.  A bottle of oil is supplied 
when the saw is new.

Remark

Remember oil can pose a hazard to health and
and the environment.  Use care and proper
procedures to contain and dispose of the 
used oil.

Lubricating

There are several grease fittings on each saw unit.
Grease fittings can be found on all rollers with the
exception of the side rollers, the locking handles and
the feed motor worm drives.  (Dimas recommends
lubricating with VEIDEC POWER LUBE or equivalent
grease every 50 hours of operation)

15