2003 Sarena Bay
™
Export Owner’s Manual
Heat Status Light
The
Heat Status Light
will turn on when there is a call for heat and the heater
engages. This is a normal function. The right side of the Digital Display Window
will continue to read the current temperature while the bottom left corner will
scroll the message “
HEATING TO _ _ _
°
C
” until the hot tub reaches the set
temperature. An animated thermometer will also be displayed in the upper center
of the Digital Display Window to confirm heater activity.
If the water reaches 1
°
C (
≅
2
°
F) above the set temperature, the message
“
COOLING TO _ _ _ - CIRC PUMP & O3 OFF
” will be displayed in the
bottom left hand side of the Digital Display Window and a cooling cycle will start.
Dimension One Spas
ICON (Logo)
®
The time of day can be viewed by pushing the Dimension One Spas ICON
®
- logo
on the far right of the control panel. If no other button is pushed within 5
seconds, the display will revert to the hot tub water temperature reading. The
pre-set factory default is Fahrenheit.
Pressing the logo for 5 seconds will place the spa in the “Standby” mode and allow
the spa to be cleaned without turning off the power.
Scrolling Message Center Messages
Because of the advanced programming features of your scrolling Digital Display Window, your hot tub will
prompt you when you need to perform routine maintenance. For example:
Rinse Filters
Every other month, the top line of your Digital Display Window will read,
“
RINSE FILTERS
” and the message “
REMOVE FILTERS & RINSE WITH
HOSE... PUSH AND HOLD ICON BUTTON MORE THAN 3 SECONDS TO
RESET THIS MESSAGE
” will scroll from right to left on the bottom line of the
display.
To reset this message, push and hold the Dimension One Spas
ICON (logo)
®
located at the right hand side of the control for 3
seconds.
Clean Filters
On alternating months, the top line of your Digital Display Window will read,
“
DIRTY FILTER
” and the message “
REMOVE FILTERS & CLEAN IN
SOLUTION... PUSH AND HOLD ICON BUTTON MORE THAN 3
SECONDS TO RESET THIS MESSAGE
” will scroll from right to left on the
bottom line of the display.
To reset this message, push and hold the Dimension One Spas
ICON (logo)
®
Button located at the right hand side of the
control for 3 seconds.
25
