HydroSport
1
Screw a Butterfly Top into the OptiMount
located on
the upper wall adjacent to the rowing seat or area. Be
sure to remove the plastic insert from the OptiMount
center.
Use the OptiMounts identified by a
1
in the 1-2-3
picture.
2
Simply screw each rower into an OptiMount
on the wall on each side of
the rowing seat as previously shown. Be sure to remove the plastic insert
from the center of the OptiMount
.
Use the OptiMounts identified by a
2
in the 1-2-3 picture.
A good guide for measuring the correct installation of the rowers is to ensure that you
first screw the rower into the OptiMount until it is almost snug, then back off ½ turn.
Next continue to back it off slightly until the rings on the rower are horizontal.
23
Summary of Contents for HYDRO SPORT
